TRANSPORTATION GENERAL TERMS AND CONDITIONS
                                 (Continued)
   
          2.  Installation and Operation by Shipper - Shipper may install,
maintain and operate at its own expense, at or near the Receipt Point(s) and
the Delivery Point(s) check meters and other necessary equipment by which the
quantity of gas delivered to or by MIGC may be measured.  Where used, orifice
meters shall employ flange taps and shall be installed and operated in
accordance with the referenced Committee Report No. 3.
   
          3.  Non-interference - Measuring equipment applying to or affecting
deliveries shall be installed in such manner as to permit an accurate determin-
ation of the quantity of gas delivered and ready verification of the accuracy
of measurement.  The parties shall exercise care in the installation,
maintenance and operation of check measuring or pressure regulating equipment
on gas compressors so as to prevent any inaccuracy in the determination of the
quantity of gas being measured.
   
          4.  Calibration and Test of Measurement Equipment - Each party shall
have the right to have representatives present at the time of any installing,
cleaning, changing, repairing, inspecting, testing, calibrating or adjusting
done in connection with the other parties measuring equipment, including
calorimeters, used in the measurement of deliveries of gas.  The accuracy of
the measuring equipment, including calorimeters, shall be verified at
reasonable intervals but not more often than is found necessary in practice.
   
          5.  Electronic Flow Computers - It is recognized that electronic or
other types of flow computers have been developed that permit the direct
computation of gas flows without the use of charts.  Where the substitution of
these devices is deemed acceptable by MIGC in the exercise of its reasonable
judgement, their use for the measurement required herein will be permitted.
   
4.  NOMINATIONS, SCHEDULING AND PRIORITY OF SERVICE
   
          1.  General - Whenever Shipper desires service, Shipper shall furnish
to MIGC a separate written nomination for each nominated Receipt and Delivery
Point under each Service Agreement with a begin date and end date, for flow
which can be several days, months or years, provided the nomination begin and
end dates are within the term of the Shipper's contract.  All nominations
excluding intra-day nominations